I am trying to connect my NXT to my laptop over Bluetooth for a University project. I have followed all the steps in the Maximum NXT book but I'm still stuck.
I have the original NXT firmware installed and go through the steps to find my laptop. The brick sees the laptop but when I try to connect I just get the error 'line busy'. As far as I can tell my dongle is configured correctly, and each device can see each other. They just won't connect.
The book mentions connecting to the NXT from the lego software, but this does not work either. Ultimately I want to use iCommand to control the robot remotely, but obviously I need to get the brick to pair with the laptop first.
I have googled endlessly and searched all through this forum unsuccessfully. I have tried all obvious fixes that I can think of and yes all things bluetooth related are switched on and visible. My phones bluetooth is switched off to avoid any conflicts there also.
Can anyone help? If I have missed a post that might solve this problem then please point me in that direction.
Jochi (stressed student! )