After having installed the 0.9.1-Beta2 on an NXT brick and tested that it worked well, I tried to rename it using nxjbrowse. Since then, whenever I try to start the brick, I get the LeJOS logo for a long time, after which I get the following error message:
Code: Select all
I've tried reflashing the stock Lego NXT firmware - this one works without trouble. But reflashing the LeJOS one afterward leads me to the same error. Hardware reset with the reset pin didn't change anything either.
I'm not sure what to do at this stage to make NXJ work again on the brick - and I'm somewhat frightened by renaming a 3rd brick. Can someone help me with this?