Exception after installation lejos 0.9.1-1

[PioW]

I was upgraded my leJOS 0.9.0 -> 0.9.1-1. So I use nxjflashg to install firmware, everything was OK (in the program) but on the NXT I had exception:

Code: Select all

Exception: 29
unsupported char
at: 363:46
at: 367:26
at: 441:3
at: 65:42
at: 90:1

This exception is throws after I turn on the brick (every time). I reinstall my lejos to the 0.9.0 version but now nxjflashg don't found the NXT brick.

How can I install firmware?

[skoehler]

You have to relink and reupload you programs.
Did you set a program to autostart and the program throws the exception?

To reinstall 0.9.0, you can manually put the NXT brick in firmware update mode. Use the reset switch in the hole near the USB port.

[PioW]

Did you set a program to autostart and the program throws the exception?

No.

To reinstall 0.9.0, you can manually put the NXT brick in firmware update mode. Use the reset switch in the hole near the USB port.

Thank you, it works.

[skoehler]

Did you set a program to autostart and the program throws the exception?

No.

The exception is thrown by the startup menu. The reason is the name of your NXT. It must contain non-ASCII characters. If you can, use leJOS 0.9.0 to change the name of your NXT to something plain ASCII. Then try the upgrade to 0.9.1 again. Also, I've fixed the bug in SVN.

[maxrees]

Did you set a program to autostart and the program throws the exception?

No.

The exception is thrown by the startup menu. The reason is the name of your NXT. It must contain non-ASCII characters. If you can, use leJOS 0.9.0 to change the name of your NXT to something plain ASCII. Then try the upgrade to 0.9.1 again. Also, I've fixed the bug in SVN.

where and how does one change the name on 0.9.0 ?

[skoehler]

Did you set a program to autostart and the program throws the exception?

No.

The exception is thrown by the startup menu. The reason is the name of your NXT. It must contain non-ASCII characters. If you can, use leJOS 0.9.0 to change the name of your NXT to something plain ASCII. Then try the upgrade to 0.9.1 again. Also, I've fixed the bug in SVN.

where and how does one change the name on 0.9.0 ?

nxjbrowse should work.

[maxrees]

thx