I bricked my NXT-Brick while flashing the leJOS-firmware. During flashing my NXT-brick was regognized as "Bossa Program Port" and the flashing program stopped.
I found the solution in the RobotC-forum:http://www.robotc.net/forums/viewtopic. ... view=print
On win7-64bit I installed the Arduino-software and both the Arduino- and NXT-usb-driver are using the same id (on win-xp both programs work without any problems).
After renaming the specifig oem101.inf file and uninstalling the "Bossa Program Port"-driver I could flash the NXT-brick again and all works fine, execpt my Arduino now.
Is there any possibility to fix this?